News
GN Solids Control
[email protected]
Tel:+86-316-5276989 (China)
Tel:+1-713-8780880 (USA)
www.gnsolidsamerica.com
News
Home > News
GN Solids Control will move forward after OTC oil show
2016-05-15 10:52:49

OTC oil show is finish, which was hold in 2-5 May, 2016, in Houston, TX, USA. After about 3 month’s preparation, GN Solids Control successfully finishes the OTC oil show. We have two booths there to deeper our brand influence, equipment for show including latest model decanter centrifuge, latest model vertical cuttings dryer, High G drying shaker, shaker screen etc. The visitors can feel the high quality and premium technology equipment by touching and watching the real equipment at the big event.

\

1)  Decanter centrifuge- equal to USA Brand

14inch decanter centrifuge is most popular as the wide application and good price. The application range include mud weight cutting and fine solids removal. And also for drilling waste management. Regarding the price, we target on high end market and overseas market. this centrifuge is equivalent to Swaco 518 CENTRIFUGE / Derrick DE1000 centrifuge. But the price of USA centrifuge is much higher than our brand. The price of GN SOLIDS CONTROL or GN Solids Ameirca is much better when compared with USA brand.

\

2)  vertical cuttings dryer – equal to CSI dryer

For OBM or SBM, most client will choose VERTICAL CUTTINGS DRYER, but for WBM, you may choose High G shaker for lower operation cost.

GNCD930 vertical cuttings dryer is used for drilling cuttings treatment at rigsite or at one mud plant location where all cuttings transport to the center location for final treatment. After treatment of GN vertical cutting s dryer, the oil on cuttings can reduce to below 5%. This is same working performance as CSI dryer or SWACO dryer. GN vertical cuttings dryer already put into market for over 3 years, and the mature product is benefiting more drilling service companies, good price, stable working performance and less maintenance.

 

3) High G drying shaker

For OBM or SBM, most client will choose VERTICAL CUTTINGS DRYER, but for WBM, you may choose High G shaker for lower operation cost. High G drying shaker is same as normal shale shaker. Just the G force is bigger.  This unit is mostly used for water based mud drilling cuttings treatment. After treated, the oil on cuttings can be reduced to about 10% to 20%.

 

After OTC oil show, GN Solids Control equipment get approval from big clients in different countries. GN Solids Control will continue to do better to support better the market.