News
GN Solids Control
[email protected]
Tel:+86-316-5276989 (China)
Tel:+1-713-8780880 (USA)
www.gnsolidsamerica.com
News
Home > News
Two sets Vertical Cuttings Dryer System for Xinjiang Client
2019-07-27 08:41:00

Vertical cutting dryer system is a main part of the closed loop system for drilling fluids treatment. It is used to recover as much drilling fluids as possible by treating the wet drilling cuttings. This week, GN finished the fabrication of 2 sets vertical cuttings dryer system, and will ship out to Xinjiang Client soon. Vertical cutting dryer system is a main part of the closed loop system for drilling fluids treatment. It is used to recover as much drilling fluids as possible by treating the wet drilling cuttings. This week, GN finished the fabrication of 2 sets vertical cuttings dryer system, and will ship out to Xinjiang Client soon. 

Vertical dryer system is mostly used with good performance to treat the oil based drilling cuttings. The entire system is mainly consisting of cuttings drying module and fine solids removing module. Each module has key equipment.  

\

Cuttings Drying Module

The vertical cutting dryer equipment is the key equipment in drying module. Normally, the drilling cutting is fed into the cuttings dryer unit. Under the centrifugal force, the oil will be separated off the cuttings and pass through the screen opening to the collection groove inside the dryer unit. The opening size of the dryer screen is designed of 250, 350 and 500 microns as options for different size cuttings drying. GN cuttings dryer is equipped with flushing system and air knife system for cleaning of the mud collection groove and screen to avoid the block.   

\

Fine Solids Removing Module

The decanter centrifuge is the key machine of this module. The liquid effluence discharged from the cutting dryer will then be pumped to the decanter centrifuge for polishing treatment to remove the fine solids in drilling fluids. To make sure the performance of the decanter, GN has taken the high speed, wear part protection, material adoption into consideration in fabrication. Long time running with less maintenance ensures the working efficiency and economic benefits. 

In the vertical cuttings dryer system, the mud tank is used to mount the equipment and for drilling fluids collection and storage. Cuttings fed into the dryer and discharged from both the dryer unit and decanter could be transferred by using the screw conveyor unit that is one of GN equipment widely used for conveying solution.  

For more information on the vertical cuttings dryer system, please feel free to contact with GN Solids Control.