GN Solids Control
[email protected]
Tel:+86-316-5276989 (China)
Tel:+1-713-8780880 (USA)
Home > News
The drilling waste mud treatment system used for a foreign oil service company
2021-12-24 15:54:33

GN Solids Control is a professional manufacturer of solids control equipment and waste treatment equipment. After years of continuous development, GN Solids Control has supplied multiple sets of solids control and waste treatment equipment to customers around the world. Recently, our company has successfully provided Foreign oil service companies have produced a set of drilling waste mud treatment system, which is applied to the drilling waste treatment site.


1. GNZS594F-SGZF high G shale shaker

GNZS594F-SGZF high-G shale shaker has a greater excitation force than ordinary shale shaker, the excitation intensity can reach 8.0G, and the size of the excitation force can be adjusted to meet more working conditions and mud separation to obtain better separation Drying effect.


2. GNCD930F vertical cutting dryer

The GNCD930F spin dryer is developed by GN Solids Control for the processing of drilling cuttings. It is widely used in oil-based cuttings processing. After the drilling cuttings dryer is processed, a part of the drilling fluid can be recovered and drier oil-based cuttings can be obtained. It can achieve the result of recovering drilling fluid to save costs, and reduce the solid content, which meets the transportation and environmental protection requirements of cuttings. In order to prevent the internal sieve of the spin dryer from clogging, GN Solids Control also equips each spin dryer with a special air knife to clean the sieve basket gap and prevent the sieve basket from clogging.


Three, screw conveyor

The screw conveyor is mainly used for waste transportation in the treatment of drilling waste. The system is mainly used to receive the cuttings screened by the vibrating screen and then transport them to the cuttings dryer for separation treatment, and then configure a spiral conveyor The machine is used to receive the dry cuttings processed by the spin dryer and transport them to the designated location.


Four, spin dryer and high G screen bracket

In order to facilitate the transportation and on-site installation of the drilling waste slurry treatment system, our company also provides customers with a liftable spin dryer and a high-G shale shaker support, which can be lowered to the lowest point of the equipment during the transportation process to facilitate transportation and installation on the job site. It can be adjusted to an appropriate height for easy installation and use.


If you have drilling waste treatment job request, you can contact us at any time.