Videos
GN Solids Control
[email protected]
Tel:+86-316-5276989 (China)
Tel:+1-713-8780880 (USA)
www.gnsolidsamerica.com
Videos
Home > Videos
GN Shale Shaker & Mud Cleaner Working Video for Drilling Mud
2015-01-24 16:20:38

GN drilling mud shale shaker is the primary solids control equipment, normally used to separate solids upper 100 microns depends on the shaker screen mesh it used.The mud cleaner is a combination of desander and desilter, with a downstream shale shaker for drying solids under the hydrocylones.The desander gives separation of upper 40 microns sands, and the 4 inch desilter separate silts upper of 20 microns. So the mud cleaner normally work as the secondary and third phased solids control for drilling mud.

Mud Cleaner

GN Drilling Mud Shale Shaker and Mud Cleaner Working Video

For horizontal directional(HDD) or water well drilling, the 3 phase solids control normally is enough, but for oil drilling especially the deep well drilling, after mud cleaner, the solids control system will fit with one middle speed decanter centrifuge for barite recovery and High gravity solids separation, and one high speed decanter centrifuge for fine and ultra fine solids (Low Gravity solids) separation.The shale shaker separation principle is by linear motion shaking, the hydrocyclones desander and desilter separation principle is centrifugal force,the decanter centrifuge is also separation by high G centrifugal force.

Read more for GN Major Solids Control Equipment.